Showing 1–9 of 42 results
-
$2.992
The METRAHIT ISO AERO multimeter is a rugged portable measuring instrument for use in the field. Special version for avionics services with special low-voltage insulation measurement and data hold function. Avionics service case with special test and measuring accessories for aviation technology, consisting of measurement cables, terminals, adapters and sockets for MIL plug connectors in a waterproof, pressure-tight hard case. Insulation resistance measurement up to 3.1 GΩ with interference voltage detection test voltages: 10, 50, 100, 250, 500 V Multimeter with diverse functions (V, Ω, F, Hz) TRMS measurements: TRMS AC / AC DC for current / voltage up to 10 kHz Activatable low-pass filter, 1 kHz / -3 dB in the V AC range Direct current measurement, 100 nA to 10 A Current measurement with current sensor clamps CLIP A transformation ratio of 1 mV:1 mA to 1 mV:1 A can be selected and is taken into consideration at the display Precision temperature indicator, °C or °F, for Pt100 / Pt1000 sensors and type K thermocouples Diode measurement (IK = 1 mA, Uflow to 5.1 V) and continuity testing Display: 4¾ place, ±30,000 digits, illumination can be activated Acoustic signals for: continuity testing, dangerous contact voltages, exceeded overload limits Min-Max value storage Data memory and internal clock, power pack adapter socket IP 54 Housing protection, dust and splash protected, protective cover Bidirectional infrared interface for exchanging data with a PC Windows software available as accessory for processing and graphic display of measured values via RS 232 interface > Each Unit Includes 1 Insulation multimeter 1 Protective rubber cover 1 Condensed operating instructions 1 CD ROM with Operating instructions 1 DAkkS calibration certificate 2 Batteries, 1.5 V, type AA, installed 1 Power pack NA_X-TRA measurement cables terminals adapters and sockets for MIL plug connectors waterproof, pressure-tight hard case
-
$0
Product tHighlights Voltage from 12 1000 V AC/DC (LED / moving coil) Display levels: 12, 24, 50, 120, 230, 400, 690, 1000 V AC/DC Phase sequence / phase test (LCD), polarity test (LED) Direct display without key acknowledgment (high impedance testing) Load switched via pushbutton (high impedance testing) Intentional tripping of the RCCB Vibration alarm in the tester handle IP65 protection (dust-proof / protected against water jets) Rugged housing design with rubberized handle Overvoltage category: CAT IV 600 V, CAT III 1000 V Safety always and everywhere: no batteries required Tested and approved in accordance with DIN EN 61243-3, VDE 0682-401:2011-02
-
$1.162
The new, compact multifunction process calibrator convinces by ruggedness, simple handling, highest functionality, precision and PC system ability. The METRACAL MC rationalizes measuring, calibrating and revision work in the chemical process, laboratory and development, in the production area of electronic measurand transducers and at comparison and calibration of metrological components. Universal calibrator, simulator and multimeter mA / mV V / °C (Pt100/1000, Ni100/1000 thermocouples: J, L, T, U, K, E, S, R, B, N) / 30 2000 Ω Dual mode ÁV simultaneous calibration and measurement (U / I) Measuring and encoding in absolute terms and as percentage (scaled) Memory for measurement results: 16 MBit Frequency and pulse run generators: 1 Hz to 2 kHz Ramp and staircase functions METRAwin µ90-2 interface and calibration software Transmitter simulator (sink: 0 24 mA) DAkkS calibration certificate included Rugged, EMC compliant design Precision multimeter (V, A, Ω, F, Hz, °C / F) 30,000 (60,000) digits and triple display TRMS AC measurement to 1 kHz > Each Unit Includes 1 METRACAL MC calibrator with 2 batteries per IEC LR6 1 KS29 cable set, consisting of 3 measurement cables (1 black, 1 blue, 1 red) with angle plugs / safety plug, test probes and 3 safety caps 1 Abbreviated instructions 1 CD ROM with operating instructions in English and German, as well as other available languages 1 GH-XTRA rubber holster 1 DAkkS calibration certificate
-
$1.384
In addition to a milliohmmeter and a multimeter, an insulation tester has been integrated into the MetraHit 27I for measurements up through the gigaohm range. Especially where service and repairs in the field of aviation technology are involved, the instrument can be used in a broad range of applications. Avionik Set including: Insulation Tester, Milliohmmeter, Multimeter and Data Logger. Insulation resistance measurement 30.00 MOhm to 3.000 GOhm with adjustable test voltage of 50, 100, 250 or 500 V Milliohmmeter: 3.000 mOhm to 300.00 mOhm with 1 A measuring current and 30.00 mOhm to 30.00 Ohm with 200 mA measuring current Kelvin connection (4-wire measurement) Resistance measurement from 300 Ohm to 30 MOhm Voltage measurement from 3 to 600 VDC and 3 to 600 VAC with ±30.000 digits Frequency measurement from 300 Hz to 3 kHz DATA hold memory for up to 1200 measured values Continuity and diode testing Overload protection DAkkS calibration certificate as standard feature LCD including background illumination provided with 3 rechargeable NiMH batteries and a charger as standard equipment > > Each Unit Includes 1 METRA HIT 27I 1 GH18 protective rubber cover with carrying strap 3 size AA NiMH storage batteries 1 NA HIT 27 mains power battery charger 1 KS17-S measurement cable set 1 set of Kelvin clips KC4 (1 set = 2 each) 1 set of Kelvin probes KC27 (1 set = 2 each) 1 HC30 hard case 1 abbreviated operating instructions 1 operating instructions D/GB/F 1 adapter USB-HIT including USB cable and system software METRAwina10/METRA HIT on CD-ROM 1 DAkkS calibration certificate
-
$2.505
Compact milliohmmeter for the measurement of low value contact resistance in potentially explosive atmospheres, for example at contacts inside aircraft fuel tanks (bonding test), as well as for general low value resistance measurements inside and outside of potentially explosive atmospheres, for example on aircraft outer skins (lightning protection and wick test). Measuring ranges: 30 mΩ, 300 mΩ, 3 Ω, 30 Ω Resolution: 10 µΩ Measuring method: Kelvin connection (4-wire measurement) DATA Hold memory: 1200 measured values EX designation: Ex II 2 G EEx ia IIA T4 Prototype test certificate: INERIS 05ATEX0040 DAkkS calibration certificate Guarantee: 3 years material and workmanship 1 to 3 years for calibration (depending upon application) > Each Unit Includes 1 METRA HIT_27EX 1 GH18 protective rubber holster (blue) including carrying strap 8 Ex approved batteries 1 KC27 Kelvin probe (1 ea. – not a set) 1 KC4 Kelvin clip (1 ea. – not a set) 1 HC30 hard case 1 DAkkS calibration certificate 1 Ex certificate: INERIS 05ATEX0040 1 set operating instructions Aircraft Maintenance Manual
-
$2.505
Compact milliohmmeter for the measurement of low value contact resistance in potentially explosive atmospheres, for example at contacts inside aircraft fuel tanks (bonding test), as well as for general low value resistance measurements inside and outside of potentially explosive atmospheres, for example on aircraft outer skins (lightning protection and wick test). Measuring ranges: 30 mΩ, 300 mΩ, 3 Ω, 30 Ω Resolution: 10 µΩ Measuring method: Kelvin connection (4-wire measurement) DATA Hold memory: 1200 measured values EX designation: Ex II 2 G EEx ia IIA T4 Prototype test certificate: INERIS 05ATEX0040 DAkkS calibration certificate Guarantee: 3 years material and workmanship 1 to 3 years for calibration (depending upon application) > Each Unit Includes 1 METRA HIT 27EX 1 GH18 protective rubber holster (blue) including carrying strap 8 Ex approved batteries 1 KC27 Kelvin probe (1 ea. – not a set) 1 KC4 Kelvin clip (1 ea. – not a set) 1 HC30 hard case 1 DAkkS calibration certificate 1 Ex certificate: INERIS 05ATEX0040 1 set operating instructions
-
$1.013
In addition to a milliohmmeter and a multimeter, an insulation tester has been integrated into the MetraHit 27I for measurements up through the gigaohm range. Especially where service and repairs in the field of aviation technology are involved, the instrument can be used in a broad range of applications. Insulation resistance measurement 30.00 MOhm to 3.000 GOhm with adjustable test voltage of 50, 100, 250 or 500 V Milliohmmeter: 3.000 mOhm to 300.00 mOhm with 1 A measuring current and 30.00 mOhm to 30.00 Ohm with 200 mA measuring current Kelvin connection (4-wire measurement) Resistance measurement from 300 Ohm to 30 MOhm Voltage measurement from 3 to 600 VDC and 3 to 600 VAC with ±30.000 digits Frequency measurement from 300 Hz to 3 kHz DATA hold memory for up to 1200 measured values Continuity and diode testing Overload protection DAkkS calibration certificate as standard feature LCD including background illumination provided with 3 rechargeable NiMH batteries and a charger as standard equipment > Each Unit Includes 1 GH18 protective rubber cover with carrying strap 3 size AA NiMH storage batteries 1 KS17-S measurement cable set 1 NA HIT 27 mains power battery charger 1 set of Kelvin clips KC4 (1 set = 2 each) 1 abbreviated operating instructions 1 operating instructions D/GB/F 1 DAkkS calibration certificate
-
$774
The MetraHit 27M is a rugged, reliable and compact milliohmmeter, multimeter and a temperature measuring instrument too. It is very well suited for on-site service, as well as for a wide variety of laboratory tasks. Applications apart from general low-ohmig measurements: measuring low value contact resistances at welding seams and riveted joints determination of low-resistance transitions at outer skins of aercraft (lightning protection, wicktest), and for general low-resistance measurements > Milliohmmeter: 3.000 mOhm to 300.00 mOhm with 1 A measuring current and 30.00 mOhm to 30.00 Ohm with 200 mA measuring current Kelvin connection (4-wire measurement) Resistance measurement from 300 Ohm to 30 MOhm Voltage measurement from 3 to 600 VDC and 3 to 600 VAC with ±30,000 digits Frequency measurement from 300 Hz to 3 kHz DATA hold memory for up to 1200 measured values Continuity and diode testing Overload protection DAkkS calibration certificate as standard feature > > Each Unit Includes 1 GH18 protective rubber cover with carrying strap 3 size AA NiMH storage batteries 1 KS17-S measurement cable set 1 abbreviated operating instructions 1 operating instructions D/GB/F 1 DAkkS calibration certificate
-
$194
Voltage measurement: 0 .. 0.15 / 0 .. 0.5 V=, 0 .. 1.5 / 5 / 15 / 50 / 150 / 500 V= / ~ Input resistance: 20 kOhm / V=, 4 kOhm / V~ Current measurement: 0 .. 50 mA=, 0 .. 1.5 / 15 / 150 mA / 1.5 / 15 A= / ~ Resistance measurement: 1 Ohm .. 1 MOhm (4 ranges) Level: -15 .. 56 dB (6 ranges) Accuracy: class 2.5 Dimensions: 92 x 126 x 45 mm Weight: approx. 0.25 kg without battery Battery: 1.5 V IEC LR 6 (AA Mignon) > Each Unit Includes 1 analog resistance measuring instrument (without battery or cable set) 1 operating instructions
